How to clean the print head?

The problem of nozzle blockage in the use of the inkjet printer is mainly based on "prevention". The best way to maintain the best working condition of the nozzle is to do some appropriate and effective daily maintenance of the nozzle every day, such as squeezing out a little ink from the nozzle every day to see whether the nozzle is in the best condition, which will greatly reduce the possibility of nozzle blockage.

When you are cleaning the small character inkjet printer, in order to ensure safety, you must stop the ink line before cleaning the nozzle. After cleaning, use a blow ball to dry the residual cleaning agent in each part of the nozzle. Therefore, the usual cleaning and maintenance in accordance with the correct steps can extend the service life of the nozzle and is not easy to block when working

Nozzle cleaning procedures:

1. Loosen the screws on the sprinkler head in the direction shown in the figure.

2. Remove the nozzle cover from the sprinkler head. Clean the nozzle shell completely.

3. Put the nozzle into the wash table with a correctly grounded bowl at the bottom and start cleaning the nozzle.

4. After cleaning the nozzle, use the correct cleaner to clean the following parts of the nozzle:

Recovery tank sensing hose

Charging electrode

Deflecting plate

nozzle

Note: The cleaner must be compatible with the type of ink used in the printer.

5. Use a blow dryer to make sure there is no cleaning residue on the charging electrode slot. Remove the nozzle from the washtable.

6. Reinstall the nozzle cover on the nozzle assembly.

7. Tighten the screws on the nozzle cover in the direction shown in the figure.

8. Carefully remove the bowl from the counter and dispose of the ink solvent in the bowl according to local regulations.

Please pay attention to the whole cleaning operation to prevent debris from entering and blocking the nozzle.